VAT included


The Base-Clamp is intended for mounting on the scope.

The clamp is pushed over the scope lens over a length of 45 mm (or 35 mm for diameters of 30 and 34 mm) and screwed there. It remains permanently on the scope.

A protective film is applied to the contact surfaces at the Base-Clamp, which prevents damage and increases adhesion to the rifle scope.

As a result, the Base-Clamp as well as the device are not pulled off the scope, even using powerful calibres. A special inner contour (three-point support on the scope) enables the attachment to be precisely aligned with the scope. The bayonet on the front of the Base-Clamp is the guarantee for an absolutely repeatable alignment even after hundreds of applications.

Our Base-Clamp is made from one-piece high-quality aluminum and is protected against corrosion and wear by a hard anodized layer.


Please note the legal regulations of your local authority.

Installation is at your own risk and peril.


Data sheet

high qualitiy aluminum
black anodized