• Base-Clamp
  • Base-Clamp
  • Base-Clamp


VAT included
Size: 62mm Outer Diameter


The Base-Clamp is intended for mounting on the scope.

The clamp is pushed over the scope lens over a length of 45 mm (or 35 mm for diameters of 30 and 34 mm) and screwed there. It remains permanently on the scope.

A protective film is applied to the contact surfaces at the Base-Clamp, which prevents damage and increases adhesion to the rifle scope.

As a result, the Base-Clamp as well as the device are not pulled off the scope, even using powerful calibres. A special inner contour (three-point support on the scope) enables the attachment to be precisely aligned with the scope. The bayonet on the front of the Base-Clamp is the guarantee for an absolutely repeatable alignment even after hundreds of applications.

Our Base-Clamp is made from one-piece high-quality aluminum and is protected against corrosion and wear by a hard anodized layer.


Please note the legal regulations of your local authority.

Installation is at your own risk and peril.


Data sheet

high qualitiy aluminum
black anodized
wall thickness (mm)

Specific References